СИСТЕМА АВТОМАТИЧЕСКОЙ ТРАНСМИССИИ, Diagnostic DTC:P0560

DTC Code DTC Name
P0560 System Voltage

DESCRIPTION

The battery supplies electricity to the TCM even when the ignition switch is off. This power allows the TCM to store data such as DTC history and freeze frame data. If the battery voltage falls below a minimum level, this memory is cleared and the TCM determines that there is a malfunction in the power supply circuit. When the engine is next started, the TCM will illuminate the MIL and store the DTC.

DTC Code DTC Detection Condition Trouble Area
P0560 Open in TCM back-up power source circuit detected for 3 sec. or more (1-trip detection logic).

  • Open in back-up power source circuit

  • ECD system

  • TCM

Tech Tips

If DTC P0560 is stored, the TCM does not store other DTCs.

WIRING DIAGRAM

A01IRO2E03

INSPECTION PROCEDURE

PROCEDURE


  1. CHECK DTC OUTPUT (ECD SYSTEM DTC P0560)


    1. Connect the intelligent tester to the DLC3.

    2. Turn the ignition switch to ON.

    3. Turn the intelligent tester on.

    4. Enter the following menus: Powertrain / Engine / DTC.

    5. Read the DTCs using the intelligent tester.

      Result
      Result Proceed to
      DTCs are not output A
      P0560 is output (ECD system) B

    B

    GO TO ECD SYSTEM (DTC P0560) Click here

    A

  2. CHECK TCM (POWER SOURCE, BODY GROUND)


    1. A01IUNZE15
      Text in Illustration
      *a

      Front view of wire harness connector

      (to TCM)

      Disconnect the TCM connector.

    2. Measure the voltage according to the value(s) in the table below.

      Standard Voltage
      Tester Connection Condition Specified Condition
      C29-1 (BATT) - Body ground Always 11 to 14 V

    3. Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      C29-8 (E1) - Body ground Always Below 1 Ω

    NG

    REPAIR OR REPLACE HARNESS OR CONNECTOR (TCM - BATTERY, BODY GROUND)

    OK

    REPLACE TCM Click here