СИСТЕМА КРУИЗ-КОНТРОЛЯ (для моделей с 1WW) Cruise SET Indicator Light Circuit

DESCRIPTION

• When the ECM detects a cruise control switch ON signal from the cruise control switch, it sends it to the combination meter assembly through CAN communication. Then the cruise control SET indicator light turns on.

• The cruise control SET indicator light circuit uses CAN communication. If there is a malfunction in this circuit, check for DTCs in the CAN communication system before troubleshooting this circuit.

INSPECTION PROCEDURE

PROCEDURE

1. PERFORM ACTIVE TEST USING GTS (SET INDICATOR LIGHT)

   
   

   1. Select the Active Test, use the GTS to generate a control command, and then check that the combination meter operates Click here.

      Combination Meter

      Tester Display	Test Part	Control Range	Diagnostic Note
      Indicat. SET	Cruise control SET indicator light	ON/OFF	-

      OK
      Indicator light turns on.

   
   

   NG

   GO TO METER / GAUGE SYSTEM Click here

   OK

2. READ VALUE USING GTS (-SET SWITCH)

   
   

   1. Check the Data List for proper functioning of the SET indicator light Click here.

      Cruise Control

      Tester Display	Measurement Item/Range	Normal Condition	Diagnostic Note
      -SET SW	-SET switch signal / ON or OFF	ON: -SET switch on OFF: -SET switch off	-

      OK
      On screen, each item changes between ON and OFF according to above chart.

   
   

   NG

   REPLACE ECM Click here

   OK

   PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE Click here