СТАРТЕР (для моделей производства DENSO)

Click here
INSTALL STARTER ASSEMBLY
1. Install the starter with the 2 bolts.
  
  64 N*m 653 kgf*cm 47 ft.*lbf
2. Connect the starter wire with the nut and close the terminal cap.
  
  9.8 N*m 100 kgf*cm 87 in.*lbf
3. Connect the starter connector.
Click here
INSTALL NO. 3 AIR HOSE

Note:
Before installation, remove any oil residue from the inside of pipe and hose.
1. Align the paint mark of the No. 3 air hose with the embossed mark of the throttle body.
2. Align the paint mark of the No. 3 air hose with the embossed mark of the No. 2 air tube.
3. Tighten the clamp of the No. 3 air hose on the diesel throttle body side.
  
  6.5 N*m 66 kgf*cm 58 in.*lbf
  Tip:
  - Align the paint mark of the air hose with the embossed mark and push in the air hose so that distance B is 0 to 2 mm (0 to 0.0787 in.).
  - Position the clamp so that distance A is 4 to 9 mm (0.157 to 0.354 in.).
4. Tighten the clamp of the No. 3 air hose on the No. 2 air tube side.
  
  6.5 N*m 66 kgf*cm 58 in.*lbf
  Tip:
  - Align the paint mark of the air hose with the embossed mark and push in the air hose so that distance B is 0 to 2 mm (0 to 0.0787 in.).
  - Position the clamp so that distance A is 9 to 15 mm (0.354 to 0.591 in.).
Click here
CONNECT NO. 2 VACUUM TRANSMITTING HOSE ASSEMBLY
1. Connect the No. 2 vacuum transmitting hose.
Click here
INSTALL BATTERY CARRIER
1. Install the battery carrier with the 4 bolts.
  
  19 N*m 189 kgf*cm 14 ft.*lbf
2. Attach the 2 clamps to connect the wire harness.
Click here
INSTALL BATTERY TRAY
Click here
INSTALL BATTERY
Click here
INSTALL BATTERY INSULATOR

INSTALL BATTERY CLAMP SUB-ASSEMBLY

Attach the hook of the battery clamp to the battery carrier.
Partially tighten the nut and temporarily install the bolt.
Adjust the battery clamp position.

Tighten the nut and bolt.

for bolt
17 N*m	168 kgf*cm	12 ft.*lbf
for nut
3.5 N*m	36 kgf*cm	31 in.*lbf

Click here
INSTALL RADIATOR SUPPORT OPENING COVER
1. Установите крышку отверстия кронштейна радиатора и закрепите ее 5 фиксаторами.
Click here
INSTALL NO. 1 ENGINE COVER
1. Введите в зацепление 4 фиксатора, чтобы закрепить крышку двигателя № 1.
Click here
CONNECT CABLE TO POSITIVE BATTERY TERMINAL
Click here
CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

Note:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).
Click here
INSTALL BATTERY SERVICE HOLE COVER
1. Установите крышку технологического отверстия аккумуляторной батареи и закрепите ее фиксатором.

СТАРТЕР (для моделей производства DENSO) УСТАНОВКА