СТАРТЕР (для моделей производства DENSO) РАЗБОРКА


  1. REMOVE MAGNET STARTER SWITCH ASSEMBLY


    1. A01IPYK

      Remove the nut and disconnect the lead wire from the magnet starter switch.

    2. A01IRUR

      Remove the 2 nuts and magnet starter switch.

  2. REMOVE STARTER DRIVE HOUSING ASSEMBLY


    1. A01IR42

      Using a T30 "TORX" socket wrench, remove the 2 bolts.

    2. Pull out the yoke and starter commutator end frame assembly together with the starter armature.

    3. Remove the starter pinion drive lever.

  3. REMOVE STARTER COMMUTATOR END FRAME ASSEMBLY


    1. A01IQ9I

      Remove the 2 screws and starter commutator end frame.

      Note

      While holding down the lead wire, remove the starter commutator end frame.

  4. REMOVE STARTER ARMATURE ASSEMBLY


    1. A01INL2E02

      Disconnect the 4 brushes from the starter brush holder.


      1. Using a screwdriver, hold back the spring.

      2. Disconnect the brush from the brush holder.

    2. Remove the brush holder.

    3. A01IUJD

      Remove the starter armature from the starter yoke.

  5. REMOVE STARTER YOKE ASSEMBLY


    1. Remove the starter yoke from the starter center bearing clutch.

  6. REMOVE STARTER ARMATURE PLATE


    1. Remove the starter armature plate from the starter center bearing clutch.

  7. REMOVE PLANET GEAR


    1. A01ITN0

      Remove the 3 planet gears.