СТАРТЕР (для моделей производства VALEO) ПОВТОРНАЯ СБОРКА


  1. INSTALL STARTER ARMATURE ASSEMBLY


    1. Install the starter armature to the starter yoke.

  2. INSTALL STARTER BRUSH HOLDER ASSEMBLY


    1. A01IO10E01
      Text in Illustration
      *1 Cutout
      *2 Protrusion

      Align the protrusion of the starter brush holder with the cutout of the rubber part of the starter yoke.

    2. While compressing the springs, install the starter brush holder to the starter armature.

  3. INSTALL STARTER COMMUTATOR END FRAME ASSEMBLY


    1. A01IRKME01
      Text in Illustration
      *1 Cutout
      *2 Protrusion

      Align the protrusion of the starter commutator end frame with the cutout of the starter brush holder and install the starter commutator end frame.

  4. INSTALL STARTER CLUTCH SUB-ASSEMBLY


    1. A01IPHHE01
      Text in Illustration
      *1 Cutout
      *2 Protrusion

      Align the protrusion of the starter clutch with the cutout of the starter yoke and install the starter clutch.

    2. A01IPRR

      Install the starter pinion drive lever to the starter drive lever pin.

    3. A01IRIG

      Apply MP grease to the starter pinion drive lever and starter drive lever pin.

    4. A01INXY

      Install the starter pinion drive lever to the starter clutch.

  5. INSTALL STARTER YOKE ASSEMBLY


    1. A01IS6QE01
      Text in Illustration
      *1 Cutout
      *2 Protrusion

      Align the protrusion of the starter clutch with the cutout of the starter drive end frame.

    2. Install the starter yoke with the 2 bolts.

      Torque:
      7.5 N*m  { 76 kgf*cm, 66 in.*lbf }
  6. INSTALL MAGNET STARTER SWITCH ASSEMBLY


    1. Apply MP grease to the hook part of the magnet starter switch.

    2. Install the rubber seal.

    3. A01IS7KE01
      Text in Illustration
      *1 Cutout
      *2 Protrusion

      Align the protrusions of the plate and boot with the cutout of the starter drive housing and install the plate and boot.

    4. Install the return spring.

    5. Using a T20 "TORX" socket wrench, install the magnet starter switch with the 2 screws.

      Torque:
      3.6 N*m  { 37 kgf*cm, 32 in.*lbf }
    6. Connect the lead wire to terminal C with the nut.

      Torque:
      9.5 N*m  { 97 kgf*cm, 84 in.*lbf }