СТАРТЕР (для моделей производства DENSO) СНЯТИЕ


  1. REMOVE BATTERY SERVICE HOLE COVER


    1. A01ITOM

      Снимите фиксатор и крышку технологического отверстия аккумуляторной батареи.

  2. PRECAUTION

    Note

    After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work Click here.

  3. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  4. DISCONNECT CABLE FROM POSITIVE BATTERY TERMINAL

  5. REMOVE NO. 1 ENGINE COVER


    1. A01INMI

      Возьмитесь сзади за крышку и медленно поднимите ее, чтобы разъединить задний фиксатор крышки. Продолжайте поднимать крышку так, чтобы освободить 3 передних и боковых фиксатора крышки, после чего снимите крышку.

      Note

      Попытка освободить задний и передние фиксаторы за один прием может привести к поломке крышки.

  6. REMOVE RADIATOR SUPPORT OPENING COVER


    1. A01IRWC

      Освободите 5 фиксаторов и снимите крышку кронштейна радиатора.

  7. REMOVE BATTERY CLAMP SUB-ASSEMBLY


    1. A01IP71

      Remove the bolt and loosen the nut.

    2. Detach the hook of the battery clamp from the battery carrier, and then remove the battery clamp.

  8. REMOVE BATTERY INSULATOR

  9. REMOVE BATTERY

  10. REMOVE BATTERY TRAY

  11. REMOVE BATTERY CARRIER


    1. A01ISD1

      Detach the 2 clamps and disconnect the wire harness.

    2. Remove the 4 bolts and battery carrier.

  12. DISCONNECT NO. 2 VACUUM TRANSMITTING HOSE ASSEMBLY


    1. A01ISW7

      Disconnect the No. 2 vacuum transmitting hose from the intake manifold.

  13. REMOVE NO. 3 AIR HOSE


    1. A01ISZ1

      Loosen the 2 hose clamps.

    2. Remove the No. 3 air hose from the No. 2 air tube and diesel throttle body.

  14. REMOVE STARTER ASSEMBLY


    1. A01INZ3

      Disconnect the starter connector.

    2. Open the terminal cap, remove the nut and disconnect the starter wire.

    3. A01INO6

      Remove the 2 bolts and starter.