ДАТЧИК УРОВНЯ МАСЛА УСТАНОВКА


  1. INSTALL ENGINE OIL LEVEL SENSOR


    1. A01IPUO

      Install the sensor with the 4 bolts.

      Torque:
      7.0 N*m  { 71 kgf*cm, 62 in.*lbf }

    2. Connect the sensor connector.

  2. ADD ENGINE OIL


    1. Add new engine oil.

      Standard Oil Grade
      Oil Grade Oil Viscosity (SAE)
      ACEA C2

      - 0W-30

      - 5W-30
      Standard Capacity
      Item Specified Condition
      Drain and refill without oil filter change 5.5 liters (5.8 US qts, 4.8 Imp. qts)
      Drain and refill with oil filter change 5.9 liters (6.2 US qts, 5.2 Imp. qts)
      Dry fill 6.3 liters (6.7 US qts, 5.5 Imp. qts)

  3. INSPECT FOR OIL LEAK


    1. Warm up the engine and check for an engine oil leak.

  4. INSPECT ENGINE OIL LEVEL


    1. Warm up the engine, stop the engine and wait 5 minutes. The engine oil level should be between the dipstick low level mark and full level mark.

      If low, check for leakage and add oil up to the full level mark.

      Note

      Do not fill engine oil above the full level mark.

  5. INSTALL NO. 1 ENGINE UNDER COVER


    1. A01IQXZ

      Install the engine under cover with the 9 clips.