КОНТАКТНЫЙ ДАТЧИК ДАВЛЕНИЯ МАСЛА УСТАНОВКА


  1. INSTALL ENGINE OIL PRESSURE SWITCH ASSEMBLY


    1. Remove the adhesive from the threads of the oil pressure switch and the bolt hole of the oil filter bracket.

    2. A01IQK9E01
      Text in Illustration
      *1 Adhesive

      Apply adhesive to 2 or 3 threads of the oil pressure switch.

      Adhesive
      Toyota Genuine Adhesive 1344, Three Bond 1344 or equivalent

      Note

      Do not apply adhesive to the oil inlet port of the sensor.

    3. A01IOB2E01

      Using SST, install the engine oil pressure switch.

      SST
      09224-00010
      Torque:
      without SST
      13 N*m  { 133 kgf*cm, 10 ft.*lbf }
      with SST
      12 N*m  { 122 kgf*cm, 9 ft.*lbf }

      Tech Tips


      • Use a torque wrench with a fulcrum length of 300 mm (11.8 in.).

      • Make sure SST and the wrench are connected in a straight line.

      Note

      Do not start the engine for at least 1 hour after installation.

    4. Connect the engine oil pressure switch connector.

  2. ADD ENGINE OIL


    1. Add new engine oil.

      Standard Oil Grade
      Oil Grade Oil Viscosity (SAE)
      ACEA C2

      - 0W-30

      - 5W-30

      Standard Capacity
      Item Specified Condition
      Drain and refill without oil filter change 5.5 liters (5.8 US qts, 4.8 Imp. qts)
      Drain and refill with oil filter change 5.9 liters (6.2 US qts, 5.2 Imp. qts)
      Dry fill 6.3 liters (6.7 US qts, 5.5 Imp. qts)
  3. INSPECT FOR OIL LEAK


    1. Warm up the engine and check for an engine oil leak.

  4. INSPECT ENGINE OIL LEVEL


    1. Warm up the engine, stop the engine and wait 5 minutes. The engine oil level should be between the dipstick low level mark and full level mark.

      If low, check for leakage and add oil up to the full level mark.

      Note

      Do not fill engine oil above the full level mark.

  5. INSTALL RADIATOR SUPPORT OPENING COVER


    1. A01IQ0Z

      Install the radiator support opening cover with the 6 clips.

  6. INSTALL NO. 1 ENGINE COVER


    1. A01INMI

      Введите в зацепление 4 фиксатора, чтобы закрепить крышку двигателя № 1.

  7. INSTALL NO. 1 ENGINE UNDER COVER


    1. A01IQXZ

      Install the engine under cover with the 9 clips.