МОНОЛИТНЫЙ КАТАЛИТИЧЕСКИЙ НЕЙТРАЛИЗАТОР СНЯТИЕ


  1. REMOVE AIR FUEL RATIO SENSOR

    Click here

  2. REMOVE EXHAUST GAS TEMPERATURE SENSOR


  3. REMOVE WINDSHIELD WIPER MOTOR ASSEMBLY

    Click here

  4. REMOVE OUTER COWL TOP PANEL


    1. A01IO5B

      Выверните 9 болтов и снимите наружную верхнюю панель кожуха

  5. REMOVE NO. 2 ENGINE UNDER COVER


    1. A01IOL8

      Освободите 4 фиксатора и снимите защиту картера двигателя № 2.

  6. REMOVE FRONT FLOOR CENTER BRACE


    1. A01IOAZ

      Выверните 4 болта и снимите передний центральный подкос пола.

  7. REMOVE FRONT EXHAUST PIPE ASSEMBLY


    1. Remove the 4 bolts and 4 compression springs.

    2. Disconnect the front exhaust pipe assembly from the 3 exhaust pipe supports.

    3. Remove the 2 gaskets.

  8. DISCONNECT NO. 1 VACUUM TRANSMITTING HOSE


    1. A01IU3T

      Disconnect the No. 1 vacuum transmitting hose.

  9. REMOVE NO. 1 MANIFOLD CONVERTER INSULATOR


    1. A01IU8J

      Remove the 7 bolts, nut and No. 1 manifold converter insulator.

  10. REMOVE NO. 1 EXHAUST MANIFOLD HEAT INSULATOR


    1. A01IPTD

      Remove the 2 bolts and No. 1 exhaust manifold heat insulator.

  11. REMOVE EXHAUST MANIFOLD CONVERTER SUB-ASSEMBLY


    1. A01ITNJ

      Remove the 2 bolts, 2 nuts and manifold stay.

    2. A01ITH7

      Remove the bolt and No. 2 manifold converter insulator.

    3. A01ITHI

      Loosen the V-band clamp.

    4. Remove the 3 nuts, 2 bolts, V-band clamp, gasket, engine bracket and exhaust manifold converter sub-assembly.

      A01IUK8E01
      Text in Illustration
      *1 Engine Bracket *2 Exhaust Manifold Converter Sub-assembly
      *3 No. 2 Manifold Stay - -