ДАТЧИК ТЕМПЕРАТУРЫ ОТРАБОТАВШИХ ГАЗОВ (для датчика 2) УСТАНОВКА


  1. INSTALL EXHAUST GAS TEMPERATURE SENSOR (for Sensor 2)

    Note

    If the exhaust gas temperature sensor is dropped, replace it with a new one.


    1. Using a 14 mm union nut wrench, install the exhaust gas temperature sensor.

      Torque:
      30 N*m  { 306 kgf*cm, 22 ft.*lbf }

      Note

      Use the formula to calculate special torque values for situations where a union nut wrench is combined with a torque wrench Click here.

    2. Pass the sensor harness through the hook on the cylinder head cover side.

    3. Connect the sensor harness to the bracket clamp.

    4. Connect the exhaust gas temperature sensor connector.

  2. INSPECT FOR EXHAUST GAS LEAK

    При наличии утечки газа затяните соединения в местах утечки. При необходимости замените поврежденные детали.

  3. INSTALL NO. 1 ENGINE COVER


    1. A01IQK8E02
      Обозначения на рисунке
      *a Точки установки

      Введите в зацепление 4 фиксатора, чтобы закрепить крышку двигателя № 1.

      Tech Tips

      Устанавливая фиксаторы, нажимайте на выступы в верхней части крышки двигателя № 1 в точках установки фиксаторов.