ДАТЧИК ТЕМПЕРАТУРЫ ОТРАБОТАВШИХ ГАЗОВ СНЯТИЕ


  1. REMOVE ENGINE ASSEMBLY

    Click here

  2. REMOVE NO. 1 MANIFOLD CONVERTER INSULATOR


    1. A01IO22

      Remove the 5 bolts and No. 1 manifold converter insulator.

  3. REMOVE MANIFOLD STAY


    1. A01IUEH

      Remove the bolt, nut and manifold stay.

  4. REMOVE NO. 2 MANIFOLD STAY


    1. A01IQ6M

      Remove the 3 bolts and No. 2 manifold stay.

  5. REMOVE NO. 2 EXHAUST MANIFOLD STAY


    1. A01IUQ6

      Remove the 2 bolts, nut and No. 2 exhaust manifold stay.

  6. REMOVE EXHAUST MANIFOLD CONVERTER SUB-ASSEMBLY


    1. A01IRLJ

      Disconnect the 2 connectors.

    2. A01IQ9Q

      Remove the 3 nuts, exhaust manifold converter and gasket.

  7. REMOVE EXHAUST GAS TEMPERATURE SENSOR (for Upper Side)

    Note

    If the sensor is dropped, replace it with a new one.


    1. A01IUQ4

      Detach the sensor connector clamp.

    2. Using a 14 mm union nut wrench, loosen the union nut.

    3. Remove the nut, clamp and sensor.

  8. REMOVE EXHAUST GAS TEMPERATURE SENSOR (for Lower Side)

    Note

    If the sensor is dropped, replace it with a new one.


    1. A01ISWW

      Detach the sensor connector clamp.

    2. Using a 14 mm union nut wrench, remove the sensor.