ДАТЧИК ТЕМПЕРАТУРЫ ТОПЛИВА УСТАНОВКА


  1. INSTALL FUEL TEMPERATURE SENSOR


    1. Apply a light coat of fuel to a new O-ring.

    2. Install the O-ring to the fuel temperature sensor.

    3. Using a 17 mm (12P) deep socket wrench, install the fuel temperature sensor to the fuel feed line.

      Tech Tips

      Refer to "SPECIFICATIONS - STANDARD BOLT" for the tightening torque.

    4. Connect the fuel temperature sensor connector.

  2. INSTALL RADIATOR SUPPORT OPENING COVER


    1. Установите крышку отверстия кронштейна радиатора и введите в зацепление 4 крюка.

    2. Установите 3 фиксатора.

  3. INSPECT FOR FUEL LEAK


    1. Check fuel pump operation.


      1. Connect the GTS to the DLC3.

      2. Turn the ignition switch to ON and turn the GTS on.

        Note

        Do not start the engine.

      3. Enter the following menus: Powertrain / Engine and ECT / Active Test / Actuator Test of FPC (EU5).

      4. Check for pressure in the fuel inlet tube from the fuel line. Check that sounds of fuel flowing from the fuel tank can be heard. If no sounds can be heard, check the No. 1 integration relay, fuel suction with pump and gauge tube assembly, ECM and wiring connectors.

    2. Inspect for fuel leaks.


      1. Check that there are no fuel leaks from the fuel system after doing any maintenance or repairs. If there is a fuel leak, repair or replace parts as necessary.

    3. Turn the ignition switch off.

    4. Disconnect the GTS from the DLC3.

  4. INSTALL NO. 1 ENGINE COVER


    1. A01IQK8E02
      Обозначения на рисунке
      *a Точки установки

      Введите в зацепление 4 фиксатора, чтобы закрепить крышку двигателя № 1.

      Tech Tips

      Устанавливая фиксаторы, нажимайте на выступы в верхней части крышки двигателя № 1 в точках установки фиксаторов.