ЗАДНИЙ САЛЬНИК КОЛЕНЧАТОГО ВАЛА УСТАНОВКА


  1. INSTALL REAR ENGINE OIL SEAL


    1. A01ITTBE01

      Using SST, tap in a new rear engine oil seal until its surface is flush with the rear oil seal retainer edge.

      SST
      09608-36010
      09950-70010   ( 09951-07100 )

      Note

      Do not tap the rear engine oil seal at an angle.

  2. INSTALL FLYWHEEL WITH DAMPER ASSEMBLY


    1. Install the crankshaft position sensor plate to the crankshaft.

    2. Temporarily install the flywheel with damper assembly with 8 new bolts.

    3. A01INASE01

      Using SST, fix the flywheel with damper assembly.

      SST
      PZ4TB-04939-38
    4. A01ITLWE01

      Using SST, tighten the 8 bolts.

      SST
      PZ4TB-04910-18
      Torque:
      120 N*m  { 1224 kgf*cm, 89 ft.*lbf }

    5. Remove SST.

  3. INSTALL CLUTCH DISC ASSEMBLY


    1. A01IRNXE01

      Insert SST into the clutch disc, and then insert them into the flywheel.

      SST
      09301-00310

      Note

      Insert the clutch disc with the disc facing in the correct direction.

  4. INSTALL CLUTCH COVER ASSEMBLY


    1. A01IUBJE01
      Text in Illustration
      *a Matchmark

      Align the matchmark on the clutch cover with the one on the flywheel.

    2. Install and tighten the 6 bolts uniformly in the order shown in the illustration, starting with the bolt located near the knock pin on the top.

      Torque:
      19 N*m  { 195 kgf*cm, 14 ft.*lbf }

      Note


      • Be sure to uniformly tighten the bolts 180° at a time according to the order in the illustration.

      • Move SST up and down, right and left lightly after checking that the clutch disc assembly is in the center, and then tighten the bolts.

  5. INSPECT AND ADJUST CLUTCH COVER ASSEMBLY


    1. A01ISYYE01

      Using a dial indicator with a roller instrument, measure the diaphragm spring tip alignment.

      Maximum misalignment
      1.3 mm (0.0512 in.)

      If the misalignment is more than the maximum, using SST, adjust the diaphragm spring tip alignment.

      SST
      09333-00013

  6. INSTALL MANUAL TRANSAXLE ASSEMBLY

    Click here