СИСТЕМА ECD (для DPF) ПРОВЕРКА / СБРОС КОДОВ DTC

Note

When the diagnosis system is changed from normal mode to check mode or vice-versa, all DTCs and freeze frame data stored in normal mode are cleared. Before changing modes, always check and make a note of DTCs and freeze frame data.

Tech Tips


  • DTCs which are stored in the ECM can be output to the intelligent tester. The intelligent tester can output current and pending DTCs.

  • Some DTCs are not stored if the ECM does not detect the same malfunction again during a second consecutive driving cycle. However, such malfunctions, detected on only one occasion, are stored as pending DTCs.


  1. CHECK DTC (Using Intelligent Tester)


    1. Connect the intelligent tester to the DLC3.

    2. Turn the ignition switch to ON.

    3. Turn the tester on.

    4. Enter the following menus: Powertrain / Engine and ECT / DTC.

    5. Check the DTC(s) and freeze frame data, and then write them down.

    6. Check the details of the DTC(s) Click here.

  2. CLEAR DTC (Using Intelligent Tester)


    1. Connect the intelligent tester to the DLC3.

    2. Turn the ignition switch to ON.

    3. Turn the tester on.

    4. Enter the following menus: Powertrain / Engine and ECT / DTC / Clear.

    5. Press the YES button.

  3. CLEAR DTC (Without using Intelligent Tester)


    1. Perform either one of the following operations.


      1. Disconnect the cable from the negative (-) battery terminal for more than 1 minute.

      2. A01IO4RE01

        Remove the EFI MAIN fuse from the engine room No. 1 relay block for more than 1 minute.