ДАТЧИК СОСТАВА ТОПЛИВОВОЗДУШНОЙ СМЕСИ (датчик 1) УСТАНОВКА

INSTALL AIR FUEL RATIO SENSOR

1. 

   Text in Illustration

   *a	Fulcrum Length

   Using SST, install the air fuel ratio sensor.

   SST

   09224-00011

   Torque:

   without SST

   50 N*m  { 510 kgf*cm, 37 ft.*lbf }

   with SST

   45 N*m  { 463 kgf*cm, 33 ft.*lbf }

   Note

   If an air fuel ratio sensor has been struck or dropped, replace it.

   Tech Tips

   
   

   • Use a torque wrench with a fulcrum length of 300 mm (11.8 in.). When using a torque wrench with a fulcrum length that is not 300 mm (11.8 in.), calculate the torque specification for the torque wrench and SST based on the "without SST" torque specification.

   • Make sure SST and the wrench are connected in a straight line.

   • Perform "Inspection After Repairs" after replacing the air fuel ratio sensor Click here.

2. 

   Text in Illustration

   *1	Air Fuel Ratio Sensor Connector
   *2	Bracket
   *a	1.5 mm (0.0591 in.) or less

   Lower the air fuel ratio sensor connector to the position shown in the illustration and connect the air fuel ratio sensor connector.

3. Attach the 2 clamps.

PERFORM AIR FUEL RATIO SENSOR INITIALIZATION

Click here