ДАТЧИК СОСТАВА ТОПЛИВОВОЗДУШНОЙ СМЕСИ (датчик 1) УСТАНОВКА

INSTALL AIR FUEL RATIO SENSOR

1. 

   Text in Illustration

   *a	Fulcrum Length

   Using SST, install the air fuel ratio sensor.

   SST

   09224-00010

   Torque:

   without SST

   50 N*m  { 510 kgf*cm, 37 ft.*lbf }

   with SST

   45 N*m  { 463 kgf*cm, 33 ft.*lbf }

   Note

   If an air fuel ratio sensor has been struck or dropped, replace it.

   Tech Tips

   
   

   • Use a torque wrench with a fulcrum length of 300 mm (11.8 in.). When using a torque wrench with a fulcrum length that is not 300 mm (11.8 in.), calculate the torque specification for the torque wrench and SST based on the "without SST" torque specification.

   • Make sure SST and the wrench are connected in a straight line.

   • Perform "Inspection After Repairs" after replacing the air fuel ratio sensor Click here.

2. 

   Text in Illustration

   *1	Air Fuel Ratio Sensor Connector
   *2	Bracket
   *a	1.5 mm (0.0591 in.) or less

   Lower the air fuel ratio sensor connector to the position shown in the illustration and connect the air fuel ratio sensor connector.

3. Attach the clamp.

CONNECT SENSOR INSULATOR

1. Connect the sensor insulator with the nut.

   Torque:

   8.0 N*m  { 82 kgf*cm, 71 in.*lbf }

PERFORM AIR FUEL RATIO SENSOR INITIALIZATION

Click here