ECM УСТАНОВКА


  1. INSTALL ECM


    1. Install the No. 2 ECM bracket to the ECM with the 2 screws.

      Torque:
      3.0 N*m  { 31 kgf*cm, 27 in.*lbf }

    2. Install the No. 1 ECM bracket to the ECM with the 2 screws.

      Torque:
      3.0 N*m  { 31 kgf*cm, 27 in.*lbf }

    3. Install the ECM with bracket with the 2 bolts.

      Torque:
      8.0 N*m  { 82 kgf*cm, 71 in.*lbf }
    4. A01IOA7

      Connect the 2 ECM connectors and lower the 2 levers.

      Note


      • When connecting the ECM connector, make sure that dirt, water or other foreign matter is not stuck between the ECM connector and ECM.

      • Make sure that the 2 levers are securely lowered.

  2. CONNECT NO. 1 AIR CLEANER INLET


    1. Connect the No. 1 air cleaner inlet with the bolt.

      Torque:
      7.0 N*m  { 71 kgf*cm, 62 in.*lbf }

  3. INSTALL AIR CLEANER CASE SUB-ASSEMBLY


    1. Install the air cleaner case sub-assembly with the 3 bolts.

      Torque:
      7.0 N*m  { 71 kgf*cm, 62 in.*lbf }

  4. INSTALL AIR CLEANER FILTER ELEMENT SUB-ASSEMBLY

  5. INSTALL AIR CLEANER CAP SUB-ASSEMBLY WITH AIR CLEANER HOSE ASSEMBLY


    1. A01ISD7E01
      Text in Illustration
      *1 Retainer

      Connect the air cleaner hose assembly to the turbocharger sub-assembly and lock the retainer as shown in the illustration.

    2. Attach the 2 clamps to install the air cleaner cap sub-assembly.

    3. Connect the ventilation hose to the cylinder head cover sub-assembly.

    4. Attach the clamp and connect the No. 2 fuel hose to the air cleaner hose assembly.

    5. Attach the clamp and connect the No. 1 fuel hose to the air cleaner hose assembly.

    6. Attach the clamp and connect the vacuum hose to the air cleaner hose assembly.

    7. Attach the clamp and connect the mass air flow meter sub-assembly connector.

  6. INSTALL RADIATOR SUPPORT OPENING COVER


    1. Установите крышку отверстия кронштейна радиатора и введите в зацепление 4 крюка.

    2. Установите 3 фиксатора.

  7. INSTALL NO. 1 ENGINE COVER


    1. A01IQK8E02
      Обозначения на рисунке
      *a Точки установки

      Введите в зацепление 4 фиксатора, чтобы закрепить крышку двигателя № 1.

      Tech Tips

      Устанавливая фиксаторы, нажимайте на выступы в верхней части крышки двигателя № 1 в точках установки фиксаторов.

  8. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  9. PERFORM REGISTRATION

    Click here

  10. PERFORM INITIALIZATION

    Click here