КОРПУС ДРОССЕЛЬНОЙ ЗАСЛОНКИ ДИЗЕЛЬНОГО ДВИГАТЕЛЯ СНЯТИЕ


  1. REMOVE RADIATOR ASSEMBLY

    Click here

  2. REMOVE WIRE HARNESS CLAMP BRACKET


    1. A01ITUN

      Detach the 2 clamps.

    2. A01IR12

      Using a T27 "TORX" socket wrench, remove the 2 bolts.

    3. Remove the bolt and wire harness clamp bracket.

  3. REMOVE NO. 3 AIR HOSE


    1. A01IUJF

      Loosen the hose clamp and remove the No. 3 air hose from the air tube assembly.

  4. REMOVE DIESEL THROTTLE BODY ASSEMBLY


    1. A01ISLT

      Detach the water by-pass hose assembly and radiator hose sub-assembly from the air tube assembly.

    2. A01INQ5

      Disconnect the intake air temperature sensor connector.

    3. A01ITA2

      Disconnect the No. 7 engine wire connector and detach the clamp.

    4. A01ITPV

      Using a T27 "TORX" socket wrench, remove the bolt and disconnect the air tube assembly from the cylinder block sub-assembly.

    5. A01ISNM

      Using an E8 "TORX" socket wrench, remove the 3 bolts and diesel throttle body assembly with air tube assembly and gasket.

    6. Detach the 2 claws and remove the air tube assembly from the diesel throttle body assembly.

    7. Remove the gasket from the air tube assembly.

    8. A01IOTV

      Disconnect the diesel throttle body assembly connector.