CAMSHAFT POSITION SENSOR INSTALLATION

PROCEDURE


  1. INSTALL CAMSHAFT POSITION SENSOR


    1. Clean and degrease the threads of the bolt for the camshaft position sensor.

    2. Apply a light coat of engine oil to the O-ring of the camshaft position sensor.

      Note

      Make sure that the O-ring is not cracked or moved out of place during installation.

    3. A0009PKE06
      Text in Illustration
      *1 Adhesive

      Apply adhesive to 2 or 3 threads of the bolt.

      Adhesive
      Toyota Genuine Adhesive 1324, Three Bond 1324 or equivalent.

    4. Install the camshaft position sensor with the bolt.

      Torque:
      10 N*m  { 102 kgf*cm, 7 ft.*lbf }

    5. Connect the camshaft position sensor connector.

  2. INSPECT FOR OIL LEAK

  3. INSTALL NO. 1 ENGINE COVER SUB-ASSEMBLY

    Click here