Click here

THROTTLE BODY INSTALLATION

Click here
Click here

PROCEDURE


  1. Click here

    INSTALL THROTTLE WITH MOTOR BODY ASSEMBLY


    1. Install a new gasket to the intake manifold.

    2. Install the throttle with motor body assembly and fuel tube bracket with the 4 bolts.

      10 N*m 102 kgf*cm 7 ft.*lbf

    3. Connect the throttle with motor body assembly connector.

    4. Connect the 2 water by-pass hoses to the throttle with motor body assembly.

    5. Connect the 2 clamps.

  2. Click here

    INSTALL AIR CLEANER CAP SUB-ASSEMBLY


    1. Connect the air cleaner cap sub-assembly with the hose clamp.

    2. A0004BZE01

      Connect the 2 fuel vapor feed hoses as shown in the illustration.

      Table 1. Text in Illustration
      *1 Retainer
      *a Push
      Note:

      • Check that there are no scratches or foreign matter around the connecting parts of the fuel tube connector and pipe before performing this work.

      • Connect the fuel tube connector and push the retainer in until the retainer makes a "click" sound to lock the claws of the retainer.

      • After connecting the fuel vapor feed hose to the fuel tube connector, check that the fuel vapor feed hose is securely connected by pulling on the fuel tube connector and the fuel vapor feed hose.

    3. A0005F2E03

      Connect the 2 hinges of the air cleaner cap sub-assembly.

      Table 2. Text in Illustration
      *a Hinge
      *b Clamp

    4. Install the air cleaner cap sub-assembly with the 2 clamps.

    5. Connect the wire harness clamp and connector.

    6. Connect the ventilation hose to the cylinder head cover.

    7. Connect the mass air flow meter connector and wire harness clamp to the air cleaner cap sub-assembly.

  3. Click here

    ADD COOLANT (for Engine)

    Click here

  4. Click here

    INSPECT FOR COOLANT LEAK (for Engine)

    Click here

  5. Click here

    INSTALL NO. 1 ENGINE COVER SUB-ASSEMBLY

    Click here

  6. Click here

    PERFORM INITIALIZATION

    Note:

    • Be sure to perform this procedure after removing and reinstalling the throttle with motor body assembly or any throttle with motor body assembly components.

    • Perform the following procedure after replacing the throttle with motor body assembly or any throttle with motor body assembly components. The following procedure should also be performed if the throttle with motor body assembly is cleaned.


    1. Turn the power switch on (IG) without operating the accelerator pedal.

      Note:

      If the accelerator pedal is operated, perform the above step again.

    2. Connect the GTS to the DLC3 and clear the DTCs (Click here).

    3. Perform "Inspection After Repair" (Click here).

    4. Start the engine and check that the MIL is not illuminated. After the engine is warmed up, check that the idle speed is within the specified range with the A/C switch off.

      Standard
      Condition Engine Idle Speed
      A/C switch off 900 to 1050 rpm
      Note:

      • Be sure to perform this step with all accessories off.

      • Make sure that the shift lever is in N.

    5. Enter the following menus: Powertrain / Engine and ECT / Data List / All Data /Throttle Sensor Position. Fully depress the accelerator pedal and check that the value is 60% or more.

    6. Perform a road test and confirm that there are no abnormalities.