MOTOR WATER JACKET COVER ASSEMBLY INSTALLATION

PROCEDURE


  1. INSTALL NO. 1 MOTOR WATER JACKET COVER ASSEMBLY


    1. Remove any remaining seal packing from the transaxle housing installation surface and bolt holes.

      Note


      • Clean and degrease the installation surface and bolt holes.

      • Do not allow any remaining seal packing to enter the coolant path when cleaning.

    2. A0006RP

      Apply seal packing in a continuous line as shown in the illustration.

      Seal packing
      Toyota Genuine Seal Packing 1282B, Three Bond 1282B or equivalent
      Standard seal diameter
      1.5 mm (0.059 in.) or more

      Note

      Remove any oil from the contact surface.

    3. Install a new No. 1 motor water jacket cover assembly to the hybrid vehicle transaxle assembly with 8 new bolts.

      Torque:
      10 N*m  { 102 kgf*cm, 7 ft.*lbf }

      Note


      • Install the No. 1 motor water jacket cover assembly within 3 minutes and tighten the bolts within 10 minutes of applying seal packing.

      • Do not add coolant within 2 hours of installing the No. 1 motor water jacket cover assembly.

      • Do not start the engine for at least 2 hours after installing the No. 1 motor water jacket cover assembly.

  2. INSTALL AUTOMATIC TRANSMISSION CASE COVER


    1. Install the automatic transmission case cover to the hybrid vehicle transaxle assembly with the 2 bolts and a new clip.

      Torque:
      12 N*m  { 120 kgf*cm, 9 ft.*lbf }

  3. INSTALL NO. 1 TRANSMISSION CONTROL CABLE BRACKET

    Click here

  4. INSTALL FRONT ENGINE MOUNTING BRACKET

    Click here

  5. INSTALL NO. 2 MOTOR WATER JACKET COVER ASSEMBLY


    1. Remove any remaining seal packing from the transaxle housing installation surface and bolt holes.

      Note


      • Clean and degrease the installation surface and bolt holes.

      • Do not allow any remaining seal packing to enter the coolant path when cleaning.

    2. A0007NK

      Apply seal packing in a continuous line as shown in the illustration.

      Seal packing
      Toyota Genuine Seal Packing 1282B, Three Bond 1282B or equivalent
      Standard seal diameter
      1.5 mm (0.059 in.) or more

      Note

      Remove any oil from the contact surface.

    3. Install a new No. 2 motor water jacket cover assembly to the hybrid vehicle transaxle assembly with 5 new bolts.

      Torque:
      10 N*m  { 102 kgf*cm, 7 ft.*lbf }

      Note


      • Install the No. 2 motor water jacket cover assembly within 3 minutes and tighten the bolts within 10 minutes of applying seal packing.

      • Do not add coolant within 2 hours of installing the No. 2 motor water jacket cover assembly.

      • Do not start the engine for at least 2 hours after installing the No. 2 motor water jacket cover assembly.

  6. INSTALL HYBRID VEHICLE TRANSAXLE ASSEMBLY

    Click here