TRANSMISSION CONTROL CABLE

INSTALL TRANSMISSION CONTROL CABLE ASSEMBLY

Note:

Before installing the transmission control cable assembly, check that the shift lever position sensor and the shift lever are in neutral.

Pass the transmission control cable assembly from the cabin to the engine compartment.
Install the transmission control cable assembly to the body with the 2 bolts.

5.0 N*m 51 kgf*cm 44 in.*lbf
Install the dash panel insulator to the original position.
Connect the transmission control cable assembly to the No. 2 transmission control cable bracket and No. 3 transmission control cable bracket.
Install a new clip to the No. 1 transmission control cable bracket.

Install the transmission control cable assembly to the No. 1 transmission control cable bracket.

Table 1. Text in Illustration
*1	Transmission Control Cable Assembly
*2	No. 1 Transmission Control Cable Bracket
*a	Claw (A)
*b	Claw (B)

Note:

Make sure that the claws (A) on the clip are securely fit into the bracket holes.
Make sure that the cable is securely installed inside of the claws (B) of the clip.

Connect the transmission control cable assembly to the control shaft lever with the nut.

13 N*m 130 kgf*cm 9 ft.*lbf
Engage the 2 claws and connect the transmission control cable assembly to the lower shift lever assembly.

Slide the slider of the transmission control cable assembly in the direction indicated by the arrow and pull the lock piece outward.

Install the end of transmission control cable assembly to the lower shift lever assembly.

Table 3. Text in Illustration

*1 Lock Piece
Note:
- Check that the lock piece is pulled up.
- Install the cable end all the way to the base of the pin.
Push the lock piece into the adjuster case.
Note:
- Check that the shift lever position sensor and the shift lever are in neutral.
- Securely push in the lock piece until the slider lock is engaged.