TRANSMISSION CONTROL CABLE INSTALLATION

Info Added 2017-08-02

PROCEDURE


  1. INSTALL TRANSMISSION CONTROL CABLE ASSEMBLY

    Note

    Before installing the transmission control cable assembly, check that the shift lever position sensor and the shift lever are in neutral.


    1. Move the shift lever to N.

    2. Pass the transmission control cable assembly from the cabin to the engine compartment.

    3. Install the transmission control cable assembly to the vehicle body with the 2 bolts.

      Torque:
      5.0 N*m  { 51 kgf*cm, 44 in.*lbf }

    4. Install the dash panel insulator to the original position.

    5. Connect the transmission control cable assembly to the No. 2 transmission control cable bracket and No. 3 transmission control cable bracket.

    6. Install a new clip to the No. 1 transmission control cable bracket.

    7. A0008FME06
      Text in Illustration
      *1 Transmission Control Cable Assembly
      *2 No. 1 Transmission Control Cable Bracket
      *a Claw (A)
      *b Claw (B)

      Connect the transmission control cable assembly to the No. 1 transmission control cable bracket.

      Note


      • Make sure that the claws (A) of the clip are securely fit into the bracket holes.

      • Make sure that the transmission control cable assembly is securely installed inside of the claws (B) of the clip.

    8. Connect the transmission control cable assembly to the control shaft lever with the nut.

      Torque:
      12 N*m  { 122 kgf*cm, 9 ft.*lbf }

    9. Engage the 2 claws to connect the transmission control cable assembly to the lower shift lever assembly.

    10. A0008ENE13
      Text in Illustration
      *1 Slider
      *2 Lock Piece
      *a Slide
      *b Pull

      Slide the slider of the transmission control cable assembly in the direction indicated by the arrow and pull the lock piece outward.

    11. A0008BEE03
      Text in Illustration
      *1 Lock Piece

      Connect the end of transmission control cable assembly to the lower shift lever assembly.

      Note


      • Check that the lock piece is pulled up.

      • Install the cable end all the way to the base of the pin.

    12. Push the lock piece into the adjuster case.

      Note


      • Check that the shift lever position sensor and the shift lever are in neutral.

      • Securely push in the lock piece until the slider lock is engaged.

  2. CONNECT NO. 1 PARKING BRAKE CABLE ASSEMBLY


    1. Connect the No. 1 parking brake cable assembly to the vehicle body with the bolt and nut.

      Torque:
      Bolt
      15 N*m  { 153 kgf*cm, 11 ft.*lbf }
      Nut
      5.4 N*m  { 55 kgf*cm, 48 in.*lbf }

    2. Install the floor carpet to the original position.

  3. INSTALL ACCELERATOR PEDAL SENSOR ASSEMBLY

    Click here

  4. INSTALL AIRBAG SENSOR ASSEMBLY

    Click here

  5. INSTALL AIR CLEANER CASE SUB-ASSEMBLY

    Click here

  6. INSTALL AIR CLEANER FILTER ELEMENT

  7. INSTALL AIR CLEANER CAP SUB-ASSEMBLY

    Click here

  8. INSTALL INLET AIR CLEANER ASSEMBLY

    Click here

  9. INSTALL COOL AIR INTAKE DUCT SEAL

    Click here

  10. INSPECT SHIFT LEVER POSITION

    Click here

  11. ADJUST SHIFT LEVER POSITION

    Click here