SHIFT LEVER POSITION SENSOR REMOVAL

PROCEDURE


  1. REMOVE FRONT WHEEL OPENING EXTENSION PAD LH

  2. REMOVE ENGINE UNDER COVER LH

  3. REMOVE FRONT WHEEL OPENING EXTENSION PAD RH

  4. REMOVE ENGINE UNDER COVER RH

  5. SEPARATE TRANSMISSION CONTROL CABLE ASSEMBLY


    1. A0005WL

      Remove the nut and disconnect the transmission control cable assembly from the control shaft lever.

    2. Using a screwdriver, disengage the 4 claws and disconnect the transmission control cable assembly with clip from the No. 1 transmission control cable bracket.

    3. Remove the clip from the transmission control cable assembly.

  6. REMOVE SHIFT LEVER POSITION SENSOR


    1. A0004K0

      Disconnect the connector from the shift lever position sensor.

    2. A00080U

      Remove the nut, washer and control shaft lever from the manual valve shaft.

    3. A0004PRE04
      Text in Illustration
      *1 Lock Plate

      Using a screwdriver, pry the tabs of the lock plate.

    4. A000643E03
      Text in Illustration
      *1 Lock Nut
      *2 Lock Plate

      Remove the lock nut and lock plate from the manual valve shaft.

    5. A0003FY

      Remove the 2 bolts and pull out the shift lever position sensor from the manual valve shaft.