SHIFT LEVER POSITION SENSOR

INSTALL SHIFT LEVER POSITION SENSOR

Install the shift lever position sensor to the manual valve shaft.
Temporarily install the 2 bolts.
Install a new lock plate with the lock nut.

6.9 N*m 70 kgf*cm 61 in.*lbf
Temporarily install the control shaft lever to the manual valve shaft.
Turn the control shaft lever clockwise until it stops, then turn it counterclockwise 2 notches.
Remove the control shaft lever from the manual valve shaft.

Align the protruding part with the neutral basic line.

Note:

There is play on the lock plate side (protruding part). Align the center point of the range of play with the neutral basic line.

Tighten the 2 bolts in the order shown in the illustration.

13 N*m 133 kgf*cm 10 ft.*lbf
Using a screwdriver, secure the lock nut with the lock plate.
Install the control shaft lever to the manual valve shaft with the washer and nut.

13 N*m 130 kgf*cm 9 ft.*lbf
Connect the shift lever position sensor connector.

CONNECT TRANSMISSION CONTROL CABLE ASSEMBLY

Connect the transmission control cable assembly to the No. 1 transmission control cable bracket.

Table 2. Text in Illustration
*1	Transmission Control Cable Assembly
*2	No. 1 Transmission Control Cable Bracket
*a	Claw (A)
*b	Claw (B)

Note:

Make sure that the claws (A) of the clip are securely fit into the bracket holes.
Make sure that the transmission control cable assembly is securely installed inside the claws (B) of the clip.