DRIVING SUPPORT ECU(for RHD) INSTALLATION

PROCEDURE

1. INSTALL DRIVING SUPPORT ECU ASSEMBLY

   
   

   1. Install the driving support ECU assembly with the nut.

      Torque:

      7.5 N*m  { 76 kgf*cm, 66 in.*lbf }

   2. Connect the connector.

2. INSTALL LOWER INSTRUMENT PANEL SUB-ASSEMBLY

   Click here

3. INSTALL INSTRUMENT PANEL BOX DOOR COVER

   Click here

4. INSTALL LOWER NO. 2 INSTRUMENT PANEL AIRBAG ASSEMBLY

   Click here

5. INSTALL NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY

   Click here

6. INSTALL INSTRUMENT SIDE PANEL LH

   Click here

7. INSTALL FRONT DOOR OPENING TRIM COVER LH

   Click here

8. INSTALL COWL SIDE TRIM BOARD LH

   Click here

9. INSTALL FRONT DOOR SCUFF PLATE LH

   Click here

10. INSTALL LOWER CENTER INSTRUMENT PANEL FINISH PANEL

    Click here

11. CONNECT CABLE TO NEGATIVE AUXILIARY BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

12. INSTALL LUGGAGE TRIM SERVICE HOLE COVER

    Click here

13. INSPECT SRS WARNING LIGHT

    Click here