DRIVING SUPPORT ECU(for RHD) REMOVAL

PROCEDURE

1. PRECAUTION

   Note

   After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notices before proceeding with work Click here.

2. REMOVE LUGGAGE TRIM SERVICE HOLE COVER

   Click here

3. DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL

   CAUTION:

   Wait at least 90 seconds after disconnecting the cable from the negative (-) auxiliary battery terminal to disable the SRS system.

   Note

   When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

4. REMOVE LOWER CENTER INSTRUMENT PANEL FINISH PANEL

   Click here

5. REMOVE FRONT DOOR SCUFF PLATE LH

   Click here

6. REMOVE COWL SIDE TRIM BOARD LH

   Click here

7. REMOVE FRONT DOOR OPENING TRIM COVER LH

   Click here

8. REMOVE INSTRUMENT SIDE PANEL LH

   Click here

9. REMOVE NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY

   Click here

10. REMOVE LOWER NO. 2 INSTRUMENT PANEL AIRBAG ASSEMBLY

    Click here

11. REMOVE INSTRUMENT PANEL BOX DOOR COVER

    Click here

12. REMOVE LOWER INSTRUMENT PANEL SUB-ASSEMBLY

    Click here

13. REMOVE DRIVING SUPPORT ECU ASSEMBLY

    
    

    1. 

       Disconnect the connector.

    2. Remove the nut and driving support ECU assembly.