DYNAMIC RADAR CRUISE CONTROL SYSTEM Cruise SET Indicator Light Circuit

DESCRIPTION


WIRING DIAGRAM

Refer to Cruise Main Indicator Light Circuit Click here.

CAUTION / NOTICE / HINT

CAUTION:

Observe the following items for safety reasons when using GTS:


  • Before using the GTS, read the instruction GTS.

  • Prevent the GTS cable from being caught on the pedals, shift lever or steering wheel when driving with the GTS connected to the vehicle.

  • When driving the vehicle for testing purposes, 2 people are required. One person should operate the GTS while the other drives the vehicle.

PROCEDURE


  1. PERFORM ACTIVE TEST USING GTS (METER DISPLAY 1)


    1. Connect the GTS to the DLC3.

    2. Turn the power switch on (IG).

    3. Turn the GTS on.

    4. Enter the following menus: Body Electrical / Combination Meter / Active Test.

    5. Perform the Active Test according to the display on the GTS.

      Combination Meter
      Tester Display Test Part Control Range Diagnostic Note
      Meter Display 1 Multi-information display OFF or All -
      OK
      The multi-information display turns on or off according to the operation of the Active Test.

    NG

    GO TO METER / GAUGE SYSTEM Click here

    OK

  2. READ VALUE USING GTS (-SET SWITCH)


    1. Turn the dynamic radar cruise control system on using the cruise control main switch (ON/OFF button).

    2. Drive at a speed between approximately 40 km/h or 25 mph and 200 km/h or 125 mph.

    3. Enter the following menus: Powertrain / Radar Cruise1 / Data List.

    4. Read the Data List according to the display on the GTS.

      Radar Cruise1
      Tester Display Measurement Item/Range Normal Condition Diagnostic Note
      -SET Switch -/SET switch status / ON or OFF

      ON: -/SET switch on

      OFF: -/SET switch off

      		 -
      Result
      Result Proceed to
      The cruise control SET indicator illuminates and turns off according to the operation of the cruise control main switch (-/SET switch). A
      The cruise control SET indicator does not illuminate but the Data List item -SET Switch changes according to the operation of the cruise control main switch (-/SET switch). B
      The cruise control SET indicator does not illuminate and the Data List item -SET Switch does not change according to the operation of the cruise control main switch (-/SET switch). C

    A

    PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE Click here

    B

    REPLACE COMBINATION METER ASSEMBLY Click here

    C

    REPLACE HYBRID VEHICLE CONTROL ECU ASSEMBLY Click here