Click here

FRONT RECOGNITION CAMERA SYSTEM, Diagnostic DTC:U0123, U0129, U0142, U0293

Click here
Click here
DTC Code DTC Name
U0123 Lost Communication with Yaw Rate Sensor Module
U0129 Lost Communication with Brake System Control Module
U0142 Lost Communication with Body Control Module "B"
U0293 Lost Communication with Hybrid Vehicle Control System
Click here

DESCRIPTION

These DTCs are output when a communication malfunction occurs between the sensors and ECUs.

DTC No. DTC Detection Condition Trouble Area
U0123 While the vehicle is being driven at 1 km/h (1 mph) or more, a communication error between the yaw rate sensor and the forward recognition camera is detected for approximately 5 seconds or more.

  • CAN communication system

  • Airbag sensor assembly (yaw rate and acceleration sensor)

  • Forward recognition camera
U0129 While the power switch is on (IG), a communication error between the skid control ECU and the forward recognition camera is detected for approximately 5 seconds or more.

  • CAN communication system

  • Brake booster with master cylinder assembly (Skid control ECU)

  • Forward recognition camera
U0142 While the power switch is on (IG), a communication error between the main body ECU (multiplex network body ECU) and the forward recognition camera is detected for approximately 5 seconds or more.

  • CAN communication system

  • Main body ECU (multiplex network body ECU)

  • Forward recognition camera
U0293 While the vehicle is being driven at 1 km/h (1 mph) or more, a communication error between the hybrid vehicle control ECU assembly and the forward recognition camera is detected for approximately 5 seconds.

  • CAN communication system

  • Hybrid vehicle control ECU assembly

  • Forward recognition camera
Click here

PROCEDURE


  1. Click here

    READ VALUE USING GTS (CAN BUS CHECK)


    1. Connect the GTS to the DLC3.

    2. Turn the power switch on (IG).

    3. Turn the GTS on.

    4. Enter the following menus: System Select / Can Bus Check.

      Result
      Result Proceed to
      All of the ECUs and sensors that are currently connected to the CAN communication system are displayed. A
      None of the ECUs and sensors that are currently connected to the CAN communication system are displayed, or some of them are not displayed. B

    5. Turn the power switch off.


  2. Click here

    CHECK DTC OUTPUT (FRONT RECOGNITION CAMERA SYSTEM)


    1. Connect the GTS to the DLC3.

    2. Turn the power switch on (IG).

    3. Turn the GTS on.

    4. Enter the following menus: Chassis / Front Recognition Camera / Trouble Codes.

    5. Clear DTCs (Click here).

    6. Turn the power switch off.


  3. Click here

    CHECK CAN COMMUNICATION SYSTEM


    1. Connect the GTS to the DLC3.

    2. Turn the power switch on (IG).

    3. Enter the following menus: System Select / Can Bus Check.

    4. Select "Communication Malfunction DTC" from the "CAN Bus Check" screen, and then select "Enter".

      OK
      CAN communication system is normal.

    5. Turn the power switch off.


    • OK

      USE SIMULATION METHOD TO CHECK (Click here)

    • NG

      GO TO DTC CHART (CAN COMMUNICATION SYSTEM) (Click here)