OIL PUMP REMOVAL

CAUTION / NOTICE / HINT

PROCEDURE

1. Click here

   INSTALL ENGINE STAND

   (Click here)

2. Click here

   REMOVE IGNITION COIL ASSEMBLY

   Click here

3. Click here

   REMOVE CYLINDER HEAD COVER SUB-ASSEMBLY

   Click here

4. Click here

   REMOVE CRANKSHAFT POSITION SENSOR

   Click here

5. Click here

   REMOVE CRANKSHAFT PULLEY

   Click here

6. Click here

   REMOVE ENGINE MOUNTING BRACKET RH

   
   
   1. 

      Remove the 5 bolts and engine mounting bracket RH.

7. Click here

   REMOVE TIMING CHAIN COVER SUB-ASSEMBLY

   
   
   1. 

      Remove the 17 bolts and 2 nuts.

   2. 

      Remove the timing chain cover sub-assembly by prying between the timing chain cover sub-assembly and cylinder head sub-assembly, camshaft housing sub-assembly, cylinder block and stiffening crankcase assembly with a screwdriver as shown in the illustration.

      Table 1. Text in Illustration

      *1	Protective Tape

      Note:

      Be careful not to damage the contact surfaces of the cylinder head sub-assembly, camshaft housing sub-assembly, cylinder block, stiffening crankcase assembly or timing chain cover sub-assembly.

      Tip:

      Tape the screwdriver tip before use.

   3. 

      Remove the 2 oil pump gaskets and oil hole cover gasket from the stiffening crankcase assembly.

8. Click here

   REMOVE TIMING CHAIN COVER OIL SEAL

   
   
   1. 

      Using a screwdriver and wooden block, pry out the timing chain cover oil seal.

      Table 2. Text in Illustration

      *1	Protective Tape
      *2	Wooden Block

      Note:

      Do not damage the surface of the oil seal press fit hole.

      Tip:

      Tape the screwdriver tip before use.