REAR CRANKSHAFT OIL SEAL INSTALLATION

PROCEDURE

1. Click here

   INSTALL REAR ENGINE OIL SEAL

   
   

   1. Using a height adjustable attachment and plate lift attachment, place the engine assembly on a flat level surface.

      Note:
      

      • Using a height adjustable attachment and plate lift attachment, place the engine assembly horizontally.

      • To prevent the oil pan sub-assembly from deforming, do not place any attachments onto the oil pan sub-assembly of the engine assembly.

      • Using an engine sling device and engine lift, secure the engine assembly before service.

   2. Apply MP grease to the lip of a new rear engine oil seal.

      Note:
      

      • Do not allow foreign matter to contact the lip of the rear engine oil seal.

      • Do not allow MP grease to contact the dust seal.

   3. 

      Using SST and a hammer, tap in the rear engine oil seal until its surface is flush with the edges of the cylinder block sub-assembly and stiffening crankcase assembly.

      09223-15030
      09950-70010	09951-07150

      Note:
      

      • Keep the lip of the rear engine oil seal free from foreign matter.

      • Do not tap in the rear engine oil seal at an angle.

2. Click here

   INSTALL FLYWHEEL SUB-ASSEMBLY

   
   
   1. 

      Using SST, hold the crankshaft.

      09213-54015

      09330-00021

      Tip:

      SST (Crankshaft pulley holding tool) Fixing bolt part No. : 91551-80650(2 pcs)

   2. 

      Apply a few drops of adhesive to 2 or 3 threads at the tip of each of the 8 bolts.

      Table 1. Text in Illustration

      *1

      Adhesive

      Adhesive
      Toyota Genuine Adhesive 1324, Three Bond 1324 or equivalent

   3. Install the flywheel sub-assembly.

   4. 

      Install and uniformly tighten the 8 bolts in the sequence shown in the illustration.

      130 N*m

      1326 kgf*cm

      96 ft.*lbf

      Note:

      Do not start the engine for at least an hour after installing the flywheel sub-assembly.

   5. Check that the crankshaft turns smoothly.

3. Click here

   INSTALL TRANSMISSION INPUT DAMPER ASSEMBLY

   
   
   1. 

      Using SST, hold the crankshaft.

      09213-54015

      09330-00021

      Tip:

      SST (Crankshaft pulley holding tool) Fixing bolt part No. : 91551-80650(2 pcs)

   2. Install the transmission input damper assembly.

   3. 

      Install and uniformly tighten the 6 bolts in the sequence shown in the illustration.

      30 N*m

      306 kgf*cm

      22 ft.*lbf

      Note:
      

      • Take care not to insert the transmission input damper assembly in the wrong direction.

4. Click here

   INSTALL HYBRID VEHICLE TRANSAXLE ASSEMBLY

   (Click here)