FRONT CRANKSHAFT OIL SEAL INSTALLATION

PROCEDURE

1. Click here

   INSTALL TIMING CHAIN COVER OIL SEAL

   
   

   1. Apply MP grease to the lip of a new timing chain cover oil seal.

      Note:
      

      • Do not allow foreign matter to contact the lip of the timing chain cover oil seal.

      • Do not allow MP grease to contact the dust seal.

   2. 

      Using SST and a hammer, tap in the timing chain cover oil seal until its surface is flush with the timing chain cover sub-assembly edge.

      09223-22010

      Note:
      

      • Keep the lip of the timing chain cover oil seal free from foreign matter.

      • Do not tap in the timing chain cover oil seal at an angle.

2. Click here

   INSTALL CRANKSHAFT PULLEY

   
   

   1. Align the crankshaft pulley key with the key groove of the crankshaft pulley.

   2. 

      Using SST, hold the crankshaft pulley and install the pulley bolt.

      Table 1. Text in Illustration

      *1	Washer
      *a	Hold
      *b	Turn

      09213-54015	09214-00030
      09213-70011
      09330-00021

      260 N*m

      2651 kgf*cm

      192 ft.*lbf

      Tip:

      Insert a few washers (thickness: approximately 5 mm (0.197 in.)) between SST(09213-70011) and SST(09214-00030).

3. Click here

   INSPECT FOR OIL LEAK

4. Click here

   INSTALL FRONT FENDER APRON SEAL RH

5. Click here

   INSTALL ENGINE UNDER COVER RH

6. Click here

   INSTALL FRONT WHEEL OPENING EXTENSION PAD RH

7. Click here

   INSTALL FRONT WHEEL RH

   103 N*m

   1049 kgf*cm

   76 ft.*lbf