BATTERY COOLING FILTER INSTALLATION

PROCEDURE

1. Click here

   INSTALL NO. 1 HYBRID BATTERY INTAKE FILTER

   
   
   1. 

      Install the No. 1 hybrid battery intake filter to the No. 1 hybrid battery intake duct.

      

      Note:

      Make sure the rubber portion of the No. 1 hybrid battery intake filter is fit behind the entire lip (A) as shown in the illustration.

      Table 1. Text in Illustration

      *a	Cross Section View of No. 1 Hybrid Battery Intake Duct
      *b	Rubber Portion of No. 1 Hybrid Battery Intake Filter

   2. 

      Apply tape as shown in the illustration to secure the No. 1 hybrid battery intake filter to the No. 1 hybrid battery intake duct.

      Table 2. Text in Illustration

      *a

      Tape

      Tip:

      If the adhesion of the tape is weak, replace it with new tape.

2. Click here

   INSTALL REAR SEAT SIDE GARNISH LH

   Click here

3. Click here

   INSTALL REAR DOOR SCUFF PLATE LH

   Click here

4. Click here

   INSTALL REAR SEAT ASSEMBLY

   (Click here)

5. Click here

   CLEAR DTC

   Tip:

   If the message "Cooling performance of the hybrid battery is low Consult a dealer" is displayed on the multi-information display, clean or replace the No. 1 hybrid battery intake filter, and clear the DTCs to reset the learning values even if no DTCs are output (Click here).