FRAME WIRE INSTALLATION

PROCEDURE


  1. INSTALL FRAME WIRE

    CAUTION:

    Wear insulated gloves.


    1. Install the frame wire with 2 new clamps shown in the illustration.

      A00094J

    2. Install the 4 nuts and 2 bolts shown in the illustration.

      A00058O
      Torque:
      8.0 N*m  { 82 kgf*cm, 71 in.*lbf }
    3. A00081G

      Install the 2 bolts shown in the illustration.

      Torque:
      8.0 N*m  { 82 kgf*cm, 71 in.*lbf }
    4. A0005V4

      Install the 2 nuts shown in the illustration.

      Torque:
      8.0 N*m  { 82 kgf*cm, 71 in.*lbf }

    5. Connect the connector and wire harness clamp shown in the illustration.

    6. A0004ER

      Connect the 2 wire harness clamps shown in the illustration.

    7. Insert the frame wire into the floor panel hole and engage the 3 claws.

    8. A0005VM

      Connect the connector and wire harness clamp shown in the illustration.

    9. A0006NCE02
      Text in Illustration
      *1 Shield Wire Ground
      *a Claw
      *b Hole

      Connect the 2 connectors to the hybrid battery junction block assembly.

      Note


      • Make sure that the ends of the frame wire do not cross over each other.

      • The connectors should be connected securely.

    10. Connect the shield wire ground to the hybrid battery junction block assembly.

      Note


      • Be sure to align the claw of the shield wire ground with the hole.

      • Be sure to install the shield wire ground in the correct direction.

  2. INSTALL NO. 4 HYBRID BATTERY SHIELD PANEL

    Click here

  3. INSTALL NO. 2 PARKING BRAKE CABLE ASSEMBLY


    1. Install the No. 2 parking brake cable assembly with the nut.

      Torque:
      6.0 N*m  { 61 kgf*cm, 53 in.*lbf }

  4. INSTALL NO. 2 FRONT FLOOR FOOTREST COVER RH


    1. A0005PQE04

      Connect the 5 clips (B) and install the No. 2 front floor footrest cover RH.

    2. Install the clip (A) to the No. 2 front floor footrest cover RH.

  5. INSTALL NO. 1 FLOOR UNDER COVER

    Click here

  6. INSTALL ROOM PARTITION PANEL INSULATOR

    Click here

  7. INSTALL REAR SEAT ASSEMBLY

    Click here

  8. INSTALL ENGINE ASSEMBLY WITH TRANSAXLE

    Click here