Click here

FRAME WIRE REMOVAL

Click here
Click here

PROCEDURE


  1. Click here

    REMOVE ENGINE ASSEMBLY WITH TRANSAXLE

    (Click here)

  2. Click here

    REMOVE REAR SEAT ASSEMBLY

    (Click here)

  3. Click here

    REMOVE ROOM PARTITION PANEL INSULATOR

    Click here

  4. Click here

    REMOVE NO. 1 FLOOR UNDER COVER

    Click here

  5. Click here

    REMOVE NO. 2 FRONT FLOOR FOOTREST COVER RH


    1. A0005PQE04

      Remove the clip (A) from the No. 2 front floor footrest cover RH.

    2. Disconnect the 5 clips (B) and remove the No. 2 front floor footrest cover RH.

  6. Click here

    REMOVE NO. 2 PARKING BRAKE CABLE ASSEMBLY


    1. A0006PM

      Remove the nut and disconnect the No. 2 parking brake cable assembly.

  7. Click here

    REMOVE NO. 4 HV BATTERY SHIELD PANEL

    Click here

  8. Click here

    REMOVE FRAME WIRE

    CAUTION:

    Wear insulated gloves.


    1. A00091XE02

      Disconnect the shield wire ground from the No. 1 hybrid battery shield sub-assembly.

      Table 1. Text in Illustration
      *1 Shield Wire Ground

    2. Disconnect the 2 connectors from the hybrid battery junction block assembly.

      Note:

      Insulate the removed connectors with insulating tape.

    3. A0005VM

      Disconnect the wire harness clamp and connector.

    4. A0009N6

      Disengage the 3 claws and push the frame wire out from the floor panel.

    5. A0004ER

      Disconnect the 2 wire harness clamps.

    6. A0005V4

      Disconnect the wire harness clamp and connector.

    7. Remove the 2 nuts.

    8. A00081G

      Remove the 2 bolts.

    9. A00058O

      Remove the 2 bolts and 4 nuts.

    10. A00094J

      Disconnect the 2 clamps and remove the frame wire.

      Tip:

      • When removing the clamp, break the claw on the clamp.

      • The clamp cannot be reused.