COMBINATION SWITCH INSPECTION

PROCEDURE


  1. INSPECT INTEGRATION CONTROL AND PANEL ASSEMBLY


    1. Inspect ECO mode switch


      1. A00070XE25
        Text in Illustration
        *a

        Component without harness connected

        (Integration Control and Panel Assembly)

        Measure the resistance according to the value(s) in the table below.

        Standard Resistance
        Tester Connection Condition Specified Condition
        4 (ECU) - 5 (E) ECO mode switch being turned and held at ECO position Below 10 Ω
        ECO mode switch not turned 10 kΩ or higher

        If the result is not as specified, replace the integration control and panel assembly.

    2. Inspect NORMAL mode switch


      1. A00070XE26
        Text in Illustration
        *a

        Component without harness connected

        (Integration Control and Panel Assembly)

        Measure the resistance according to the value(s) in the table below.

        Standard Resistance
        Tester Connection Condition Specified Condition
        2 (B) - 5 (E) NORMAL mode switch being pushed and held Below 10 Ω
        NORMAL mode switch not pushed 10 kΩ or higher

        If the result is not as specified, replace the integration control and panel assembly.

    3. Inspect SPORT mode switch


      1. A00070XE27
        Text in Illustration
        *a

        Component without harness connected

        (Integration Control and Panel Assembly)

        Measure the resistance according to the value(s) in the table below.

        Standard Resistance
        Tester Connection Condition Specified Condition
        3 (P) - 5 (E) SPORT mode switch being turned and held at SPORT position Below 10 Ω
        SPORT mode switch not turned 10 kΩ or higher

        If the result is not as specified, replace the integration control and panel assembly.

    4. Inspect EV drive mode switch


      1. A00070XE09
        Text in Illustration
        *a

        Component without harness connected

        (Integration Control and Panel Assembly)

        Measure the resistance according to the value(s) in the table below.

        Standard Resistance
        Tester Connection Condition Specified Condition
        1 (S) - 5 (E) EV drive mode switch being pushed and held Below 10 Ω
        EV drive mode switch not pushed 10 kΩ or higher

        If the result is not as specified, replace the integration control and panel assembly.

    5. Inspect VSC off switch


      1. A00070XE10
        Text in Illustration
        *a

        Component without harness connected

        (Integration Control and Panel Assembly)

        Measure the resistance according to the value(s) in the table below.

        Standard Resistance
        Tester Connection Condition Specified Condition
        7 (+) - 5 (E) VSC off switch being pushed and held Below 10 Ω
        VSC off switch not pushed 10 kΩ or higher

        If the result is not as specified, replace the integration control and panel assembly.

    6. Inspect illumination


      1. A0009NWE01
        Text in Illustration
        *a

        Component without harness connected

        (Integration Control and Panel Assembly)
        *b Integration Control and Panel Assembly Illumination

        Apply auxiliary battery voltage between the terminals of the switch, and check the illumination condition of the integration control and panel assembly.

        Standard
        Measurement Condition Specified Condition
        Auxiliary battery positive (+) → 8 (ILL+) Auxiliary battery negative (-) → 6 (ILL-) Illuminates

        If the result is not as specified, replace the integration control and panel assembly.