Click here

FRONT AXLE HUB ON-VEHICLE INSPECTION

Click here
Click here Click here

CAUTION / NOTICE / HINT

Note:

When the brake pedal is first depressed after replacing the brake pads or pushing back the disc brake piston, DTC C1214 may be output. As there is no malfunction, clear the DTC.

Tip:

  • Use the same procedure for the RH side and LH side.

  • The procedure listed below is for the LH side.

Click here

PROCEDURE


  1. Click here

    PRECAUTION

    Note:

    After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notice before proceeding with work (Click here).

  2. Click here

    DISABLE BRAKE CONTROL

    Click here

  3. Click here

    REMOVE FRONT WHEEL

  4. Click here

    SEPARATE FRONT DISC BRAKE CALIPER ASSEMBLY

    Click here

  5. Click here

    REMOVE FRONT DISC

    Click here

  6. Click here

    INSPECT FRONT AXLE HUB BEARING LOOSENESS


    1. A0003HN

      Using a dial indicator, check for looseness near the center of the front axle hub.

      Maximum looseness
      0.05 mm (0.00197 in.)
      Note:

      • Ensure that the dial indicator is set perpendicular to the measurement surface.

      • Keep the magnet of the dial indicator away from the front speed sensor.

      If the looseness exceeds the maximum, replace the front axle hub bearing.

  7. Click here

    INSPECT FRONT AXLE HUB RUNOUT


    1. A0004OC

      Using a dial indicator, check for runout on the surface of the front axle hub outside the hub bolts.

      Maximum runout
      0.05 mm (0.00197 in.)
      Note:

      • Ensure that the dial indicator is set perpendicular to the measurement surface.

      • Keep the magnet of the dial indicator away from the front speed sensor.

      If the runout exceeds the maximum, replace the front axle hub sub-assembly and front axle hub bearing.

  8. Click here

    INSTALL FRONT DISC

    Click here

  9. Click here

    INSTALL FRONT DISC BRAKE CALIPER ASSEMBLY

    Click here

  10. Click here

    INSTALL FRONT WHEEL

    103 N*m 1049 kgf*cm 76 ft.*lbf
  11. Click here

    CONNECT CABLE TO NEGATIVE AUXILIARY BATTERY TERMINAL


    1. Connect the cable to the negative (-) auxiliary battery terminal (Click here).

    2. Connect the reservoir level switch connector.

    3. Clear the DTCs (Click here).