REAR AXLE HUB INSTALLATION

CAUTION / NOTICE / HINT

PROCEDURE

1. INSTALL REAR AXLE HUB AND BEARING ASSEMBLY

   
   

   1. Install the rear axle hub and bearing assembly and parking brake assembly to the rear axle carrier sub-assembly with the 4 bolts.

      Torque:

      60 N*m  { 612 kgf*cm, 44 ft.*lbf }

2. INSPECT REAR AXLE HUB BEARING LOOSENESS

   Click here

3. INSPECT REAR AXLE HUB RUNOUT

   Click here

4. CONNECT SKID CONTROL SENSOR WIRE

   Click here

5. INSTALL REAR DISC

   Click here

6. INSTALL PARKING BRAKE SHOE ADJUSTING HOLE PLUG

   Click here

7. INSTALL REAR DISC BRAKE CALIPER ASSEMBLY

   Click here

8. CONNECT CABLE TO NEGATIVE AUXILIARY BATTERY TERMINAL

   
   

   1. Connect the cable to the negative (-) auxiliary battery terminal Click here.

   2. Connect the reservoir level switch connector.

   3. Clear the DTCs Click here.

9. INSTALL FRONT OUTER COWL TOP PANEL SUB-ASSEMBLY (for RHD)

   Click here

10. INSTALL WINDSHIELD WIPER MOTOR AND LINK ASSEMBLY (for RHD)

    Tech Tips

    Use the same procedure as for LHD Click here.

11. ADJUST PARKING BRAKE

    Click here

12. INSTALL REAR WHEEL

    Torque:

    103 N*m  { 1049 kgf*cm, 76 ft.*lbf }

13. CHECK FOR SPEED SENSOR SIGNAL

    Click here