Click here

REAR AXLE HUB REMOVAL

Click here
Click here

CAUTION / NOTICE / HINT

Note:

When the brake pedal is first depressed after replacing the brake pads or pushing back the disc brake piston, DTC C1214 may be output. As there is no malfunction, clear the DTC.

Tip:

  • Use the same procedure for the RH side and LH side.

  • The procedure listed below is for the LH side.

Click here

PROCEDURE


  1. Click here

    PRECAUTION

    Note:

    After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notice before proceeding with work (Click here).

  2. Click here

    DISABLE BRAKE CONTROL

    Click here

  3. Click here

    REMOVE REAR WHEEL

  4. Click here

    SEPARATE REAR DISC BRAKE CALIPER ASSEMBLY

    Click here

  5. Click here

    REMOVE PARKING BRAKE SHOE ADJUSTING HOLE PLUG

    Click here

  6. Click here

    REMOVE REAR DISC

    Click here

  7. Click here

    DISCONNECT SKID CONTROL SENSOR WIRE

    Click here

  8. Click here

    REMOVE REAR AXLE HUB AND BEARING ASSEMBLY


    1. A0003LM

      Remove the 4 bolts and the rear axle hub and bearing assembly from the rear axle carrier sub-assembly.

      Note:

      Use wire or an equivalent tool to keep the parking brake assembly from hanging down by the parking brake cable assembly.