WIPER SWITCH REMOVAL

Info Added 2017-10-06

PROCEDURE


  1. REMOVE LOWER STEERING COLUMN COVER

    Note

    Removing the lower steering column cover in the incorrect order will cause the parts to break.


    1. Release the tilt and telescopic lever and fully extend and lower the steering column assembly.

    2. Lock the tilt and telescopic lever.

    3. A001TM9

      Turn the steering wheel assembly to the left and remove the screw.

    4. A001U4S

      Turn the steering wheel assembly to the right and remove the screw.

    5. A001TAPC01
      B00495X Push

      Push the lower steering column cover and disengage the claws as shown in the illustration.

    6. A001XZ8

      Disengage the claws.

    7. Release the tilt and telescopic lever and fully extend and lift the steering column assembly.

    8. Lock the tilt and telescopic lever.

    9. A001WUVC01
      B00498X Place Hand Here
      B00497S Remove in this Direction

      Pull the lower steering column cover toward the rear of the vehicle to disengage the claw and remove the lower steering column cover.

  2. REMOVE UPPER STEERING COLUMN COVER


    1. Release the tilt and telescopic lever and fully extend and lower the steering column assembly.

    2. Lock the tilt and telescopic lever.

    3. A001SJNC01
      B00497S Separate in this Direction

      Disengage the claw to separate the upper steering column cover as shown in the illustration.

    4. A001XQG

      Disengage the claws and clips to remove the upper steering column cover from the lower instrument cover sub-assembly.

  3. REMOVE WINDSHIELD WIPER SWITCH ASSEMBLY


    1. A001YG5

      Disconnect the 2 connectors.

    2. A001XIWC01
      *a Protective Tape
      B00497S Remove in this Direction

      Using a screwdriver with its tip wrapped in protective tape, disengage the claw and remove the windshield wiper switch assembly as shown in the illustration.

      Note

      If the claw is pulled with excessive force, it may break.