WIPER AND WASHER SYSTEM OPERATION CHECK


  1. FRONT WIPER MOTOR AND LINK ASSEMBLY INSPECTION


    1. AUTO Wiper Inspection (w/ Auto Wiper System)


      1. Continuously apply water to the windshield glass in front of the rain sensor.

      2. Turn the ignition switch to ON.

      3. Move the windshield wiper switch assembly to the AUTO position.

      4. Check that the wipers move.

    2. Intermittent operation inspection (w/o Auto Wiper System)


      1. Turn the ignition switch to ON.

      2. Move the windshield wiper switch assembly to the INT position.

      3. Check that the wipers move intermittently.

  2. WASHER MOTOR AND PUMP ASSEMBLY INSPECTION


    1. Washer operation inspection (front)


      1. Turn the ignition switch to ON.

      2. Operate the washer switch (front) for approximately 0.5 seconds or more and confirm that the front wipers operate in the LO setting when the washer fluid is sprayed and that the front wipers cycle 3 times after releasing the washer switch (front).

    2. Washer operation inspection (rear) (w/ Rear Wiper)


      1. Turn the ignition switch to ON.

      2. While the windshield wiper switch assembly (rear wiper control switch) to is set to OFF, operate the washer switch (rear) for approximately 0.5 seconds or more and check that the rear wiper operates when the washer fluid is sprayed.

      3. Check that the rear wiper operates for approximately 2.5 seconds after releasing the washer switch (rear).

    3. Drip prevention wiper function


      1. Turn the ignition switch to ON.

      2. At a vehicle speed of approximately less than 4 km/h (2 mph), check that the front wipers operate for 1 cycle approximately 3 seconds after washer cooperation completes.

  3. REAR WIPER MOTOR AND BRACKET ASSEMBLY DELAY INSPECTION (w/ Rear Wiper)


    1. Turn the ignition switch to ON.

    2. Move the windshield wiper switch assembly to the INT position.

    3. Check that the rear wiper operates once approximately every 12 seconds.

  4. HEADLIGHT CLEANER MOTOR AND PUMP ASSEMBLY INSPECTION


    1. Turn the ignition switch to ON.

    2. Set the headlight dimmer switch assembly to the HEAD position.

    3. Check that the washer fluid splays from the headlight washer actuator sub-assembly when the front washer switch is first operated.

    4. Subsequently, check that for every 5 times the front washer switch is operated, the headlight cleaner system operates 1 time.