POWER WINDOW REGULATOR MOTOR(for Front Door) REMOVAL

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during the power window regulator motor removal/installation are shown below.

Necessary Procedures After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative when not Performed Link
Disconnect cable from negative (-) battery terminal Memorize steering angle neutral point Lane departure alert system (w/ Steering Control)

Click here

Simple intelligent parking assist system*1
Toyota parking assist-sensor system (w/ Simple Intelligent Parking Assist System)*1
Pre-collision system
Initialize back door lock Power door lock control system

Click here

Drive the vehicle until stop and start control is permitted (approximately 5 to 60 minutes)*2 Stop and start system

Click here


  • Door window regulator assembly

  • Power window regulator motor assembly

  • Door glass

  • Door glass run

 Initialize Power Window Control System

  • Auto up and down function

  • Jam protection function

  • Catch protection function

  • Remote control function

  • Key-linked function

  • Wireless transmitter-linked function

  • Key-off operation function

  • Window open warning function

Click here

*1: When performing learning using the GTS.

Click here

*2: w/ Stop and start system

Tech Tips


  • Use the same procedure for RHD and LHD vehicles.

  • The procedure listed below is for LHD vehicles.

  • Use the same procedure for the RH and LH sides.

  • The procedure listed below is for the LH side.

PROCEDURE


  1. PRECAUTION

    Note

    After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.

    Click here

  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL


    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Click here

  3. REMOVE FRONT DOOR INSIDE HANDLE BEZEL PLUG

    Click here

  4. REMOVE MULTIPLEX NETWORK MASTER SWITCH ASSEMBLY WITH FRONT ARMREST BASE UPPER PANEL (for Driver Side)

    Click here

  5. REMOVE POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH FRONT ARMREST BASE UPPER PANEL (for Front Passenger Side)

    Click here

  6. REMOVE FRONT DOOR TRIM BOARD SUB-ASSEMBLY

    Click here

  7. REMOVE FRONT DOOR GLASS INNER WEATHERSTRIP

    Click here

  8. REMOVE FRONT DOOR BELT SEAL

    Click here

  9. REMOVE FRONT DOOR SERVICE HOLE COVER

    Click here

  10. REMOVE FRONT DOOR GLASS SUB-ASSEMBLY

    Click here

  11. REMOVE NO. 2 FRONT DOOR SERVICE HOLE COVER

    Click here

  12. REMOVE FRONT DOOR WINDOW REGULATOR ASSEMBLY

    Click here

  13. REMOVE POWER WINDOW REGULATOR MOTOR ASSEMBLY


    1. A005Q7M

      Using a T25 "TORX" socket wrench, remove the 3 screws and power window regulator motor assembly.