ION GENERATOR REMOVAL

Info Added 2017-10-06

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed, installed or replaced during the ion generator removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replacement Part or Procedure Necessary Procedures Effects / Inoperative when not performed Link
Disconnect cable from negative battery terminal Memorize steering angle neutral point Lane departure alert system (w/ Steering Control)

Click here

Simple intelligent parking assist system*1
Toyota parking assist-sensor system (w/ Simple Intelligent Parking Assist System)*1
Pre-collision system
Initialize back door lock Power door lock control system

Click here

Drive the vehicle until stop and start control is permitted (approximately 5 to 60 minutes)*2 Stop and start system

Click here

*1: When performing learning using the GTS.

Click here

*2: w/ Stop and start system

CAUTION:

Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing.

B00495G

Click here

Tech Tips


  • Use the same procedure for RHD and LHD vehicles.

  • The following procedure is for the LHD vehicles.

PROCEDURE


  1. REMOVE INSTRUMENT PANEL SAFETY PAD SUB-ASSEMBLY

    Click here

  2. REMOVE NO. 1 HEATER TO REGISTER DUCT SUB-ASSEMBLY

    Click here

  3. REMOVE ION GENERATOR SUB-ASSEMBLY


    1. A005PLK

      Disconnect the connector.

    2. Remove the 2 screws and ion generator sub-assembly with No. 1 ion generator bracket.

    3. A005PQR

      Remove the 2 screws, ion generator sub-assembly and air duct sub-assembly from the No. 1 ion generator bracket.