AIR CONDITIONING AMPLIFIER REMOVAL

Info Added 2017-10-06

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during the air conditioning amplifier assembly removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effects / Inoperative when not performed Link
Air conditioning amplifier assembly Initialize servo motor (Air conditioning system) DTCs are stored

for VALEO Made:

Click here

for DENSO Made:

Click here

Tech Tips


  • Use the same procedure for RHD and LHD vehicles.

  • The following procedure is for the LHD vehicles.

PROCEDURE


  1. REMOVE FRONT DOOR SCUFF PLATE LH

    Click here

  2. REMOVE COWL SIDE TRIM BOARD LH

    Click here

  3. REMOVE NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY

    Click here

  4. REMOVE AIR CONDITIONING AMPLIFIER ASSEMBLY


    1. for VALEO Made:


      1. A005PBA

        Remove the screw.

      2. A005OTMC01
        B00497S Remove in this Direction

        Disengage the guides to remove the air conditioning amplifier assembly as shown in the illustration.

      3. A005P2A

        Disconnect each connector.

    2. for DENSO Made:


      1. A005OP9

        Remove the screw.

      2. A005OTHC01
        B00497S Remove in this Direction

        Disengage the guide to remove the air conditioning amplifier assembly as shown in the illustration.

      3. A005QC1

        Disconnect each connector.