OCCUPANT DETECTION SENSOR REMOVAL

Info Added 2017-10-06

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during the occupant detection sensor removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replacement Part or Procedure Necessary Procedures Effects/Inoperative when not performed Link
Disconnect cable from negative battery terminal Memorize steering angle neutral point Lane departure alert system (w/ Steering Control)

Click here

Simple intelligent parking assist system*1
Toyota parking assist-sensor system (w/ Simple Intelligent Parking Assist System)*1
Pre-collision system
Initialize back door lock Power door lock control system

Click here

Drive the vehicle until stop and start control is permitted (approximately 5 to 60 minutes)*2 Stop and start system

Click here

*1: When performing learning using the GTS.

Click here

*2: w/ Stop and start system

CAUTION:


  • B00495G

    Be sure to read Precaution thoroughly before servicing.

    Click here

  • Wear protective gloves. Sharp areas on the parts may injure your hands.

Tech Tips


  • Use the same procedure for RHD and LHD vehicles.

  • The following procedure is for LHD vehicles.

PROCEDURE


  1. REMOVE FRONT SEAT ASSEMBLY

    Tech Tips

    Use the same procedure as for the driver side.

    Click here

  2. REMOVE FRONT SEAT INNER BELT ASSEMBLY

    Click here

  3. DISCONNECT SEPARATE TYPE FRONT SEATBACK COVER

    Tech Tips

    Use the same procedure as for the driver side.

    Click here

  4. REMOVE RECLINING HINGE OUTER COVER

    Tech Tips

    Use the same procedure as for the driver side.

    Click here

  5. REMOVE RECLINING ADJUSTER RELEASE HANDLE

    Tech Tips

    Use the same procedure as for the driver side.

    Click here

  6. REMOVE FRONT SEAT CUSHION SHIELD

    Click here

  7. REMOVE FRONT SEAT INNER CUSHION SHIELD

    Click here

  8. REMOVE SEPARATE TYPE FRONT SEATBACK ASSEMBLY

    Tech Tips

    Use the same procedure as for the driver side.

    Click here

  9. REMOVE SEPARATE TYPE FRONT SEAT CUSHION COVER WITH PAD

    Tech Tips

    Use the same procedure as for the driver side.

    Click here

  10. REMOVE OCCUPANT DETECTION SENSOR (SEPARATE TYPE FRONT SEAT CUSHION PAD)


    1. Using a screwdriver, disengage the claws to remove the occupant detection sensor (separate type front seat cushion pad) from the separate type front seat cushion cover as shown in the illustration.

      A001TXEC01
      *a Screwdriver - -