SIDE AIRBAG SENSOR(for Front Door) INSTALLATION

Info Added 2017-10-06

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure for RHD and LHD vehicles.

  • The following procedure is for LHD vehicles.

  • Use the same procedure for the RH side and LH side.

  • The following procedure is for the LH side.

PROCEDURE


  1. INSTALL DOOR SIDE AIRBAG SENSOR


    1. Check that the ignition switch off.

    2. Check that the cable is disconnected from the negative (-) battery terminal.

      CAUTION:

      Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

      B00497C

    3. Connect the connector to the door side airbag sensor.

      A001X2OC37
      *a White Housing Lock *b Connection is completed

      Note

      When connecting any airbag connector, take care not to damage the airbag wire harness.

      Tech Tips


      • Be sure to connect the connector until it is locked (when locking, make sure that a click sound can be heard).

      • When the connector is locked, the white housing lock will slide. Do not hold the white housing lock or the part (A) as it may result in an insecure connection.

    4. Before connecting the connector, check that the position of the white housing lock is as shown in the illustration.

      A001WRLC05
      *a Incorrect *b Correct
    5. A001UWZ

      Engage the claw to install the door side airbag sensor with the nut.

      Torque:
      9.0 N*m  { 92 kgf*cm, 80 in.*lbf }

      Note


      • If the door side airbag sensor has been dropped, or there are any cracks, dents or other defects in the case or connector, replace it with a new one.

      • When installing the door side airbag sensor, make sure that the SRS wiring does not interfere with or is not pinched between other parts.

      • Make sure that the door side airbag sensor claw is securely inserted into the door hole.

      • Keep the stud bolt and waterproof rubber seal free of foreign matter.

    6. Check that there is no looseness in the installed parts of the door side airbag sensor.

  2. INSTALL FRONT DOOR SERVICE HOLE COVER

    Click here

  3. INSTALL FRONT DOOR TRIM BOARD SUB-ASSEMBLY

    Click here

  4. INSTALL MULTIPLEX NETWORK MASTER SWITCH ASSEMBLY WITH FRONT DOOR UPPER ARMREST BASE PANEL (for Driver Side)

    Click here

  5. INSTALL POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH FRONT DOOR UPPER ARMREST BASE PANEL (for Front Passenger Side)

    Click here

  6. INSTALL FRONT DOOR INSIDE HANDLE BEZEL PLUG

    Click here

  7. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL


    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Click here

  8. INSPECT POWER WINDOW OPERATION

    Click here

  9. PERFORM DIAGNOSTIC SYSTEM CHECK

    Click here

  10. INSPECT SRS WARNING LIGHT

    Click here