FRONT PASSENGER AIRBAG ASSEMBLY REMOVAL

Info Added 2017-10-06

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the instrument panel passenger airbag assembly removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replacement Part or Procedure Necessary Procedures Effects/Inoperative when not performed Link
Disconnect cable from negative battery terminal Memorize steering angle neutral point Lane departure alert system (w/ Steering Control)

Click here

Simple intelligent parking assist system*1
Toyota parking assist-sensor system (w/ Simple Intelligent Parking Assist System)*1
Pre-collision system
Initialize back door lock Power door lock control system

Click here

Drive the vehicle until stop and start control is permitted (approximately 5 to 60 minutes)*2 Stop and start system

Click here

*1: When performing learning using the GTS.

Click here

*2: w/ Stop and start system

Tech Tips


  • Use the same procedure for RHD and LHD vehicles.

  • The following procedure is for LHD vehicles.

PROCEDURE


  1. PRECAUTION

    CAUTION:

    Be sure to read Precaution thoroughly before servicing.

    Click here

    B00495G

    Note

    After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.

    Click here

  2. REMOVE INSTRUMENT PANEL SAFETY PAD SUB-ASSEMBLY

    Click here

  3. REMOVE INSTRUMENT PANEL PASSENGER AIRBAG ASSEMBLY

    CAUTION:

    When storing the instrument panel passenger airbag assembly, keep the airbag deployment side facing upward.

    A001UN4C02
    B004987 Deployment Side

    1. A001VFR

      Remove the 2 screws.

    2. A001SJ9

      Disengage the hooks to remove the instrument panel passenger airbag assembly from the instrument panel safety pad sub-assembly.

      Note

      Do not damage the deployment surface of the instrument panel passenger airbag assembly.

  4. REMOVE NO. 2 INSTRUMENT PANEL WIRE


    1. A001SFTC02
      *a Protective Tape
      *b Airbag Connector
      *c Airbag Connector Lock
      *d for TMMT Made Only

      Disengage the clamp (for TMMT Made).

    2. Using a screwdriver with its tip wrapped in protective tape, release the airbag connector lock.

    3. Disconnect the airbag connector to remove the No. 2 instrument panel wire from the instrument panel passenger airbag assembly.

      Note

      When disconnecting any airbag connector, take care not to damage the airbag wire harness.