AIRBAG SYSTEM, Diagnostic DTC:B1610/13

DTC Code DTC Name
B1610/13 Front Airbag Sensor RH Malfunction

DESCRIPTION

The front airbag sensor RH circuit consists of the airbag sensor assembly and front airbag sensor RH.

The front airbag sensor RH detects impacts to the vehicle and sends signals to the airbag sensor assembly to determine if the airbags and pretensioners should be deployed.

DTC B1610/13 is stored when a malfunction is detected in the front airbag sensor RH.

DTC No. Detection Item DTC Detection Condition Trouble Area Test Mode / Check Mode
B1610/13 Front Airbag Sensor RH Malfunction

Any of the following conditions is met:


  • Front airbag sensor RH malfunction

  • Airbag sensor assembly malfunction

  • Front airbag sensor RH

  • Airbag sensor assembly

 Does not apply to test/check mode
DTC Detection Conditions:
Vehicle Condition
Pattern 1 Pattern 2
Diagnosis Condition Ignition switch ON ○ ○
Malfunction Status Front airbag sensor RH malfunction ○ -
Airbag sensor assembly malfunction - ○
Detection Time - -
Number of Trips 1 trip 1 trip

Tech Tips

DTC will be output when conditions for either of the patterns in the table above are met.

WIRING DIAGRAM

Click here

CAUTION / NOTICE / HINT

Note

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.

Click here

PROCEDURE


  1. CHECK FLOOR SIDE AIRBAG SENSOR RH


    1. A001XUQC02
      *A w/o Dual-stage SRS
      *B w/ Dual-stage SRS
      *1 Front Airbag Sensor LH
      *2 Airbag Sensor Assembly

      Turn the ignition switch off.

    2. Disconnect the cable from the negative (-) battery terminal.

      CAUTION:

      Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

    3. Interchange the front airbag sensor RH with LH and connect the connectors.

    4. Connect the cable to the negative (-) battery terminal.

    5. Clear the DTCs stored in memory.

      Click here


      Body Electrical > SRS Airbag > Clear DTCs

    6. Turn the ignition switch off.

    7. Turn the ignition switch ON, and wait for at least 60 seconds.

    8. Check for DTCs.

      Click here


      Body Electrical > SRS Airbag > Trouble Codes

      Tech Tips

      Codes other than DTCs B1610/13 and B1615/14 may be output at this time, but they are not related to this check.

      Result
      Result Proceed to
      DTCs B1610/13 and B1615/14 are not output. A
      DTC B1610/13 is output. B
      DTC B1615/14 is output. C

    9. Turn the ignition switch off.

    10. Disconnect the cable from the negative (-) battery terminal.

      CAUTION:

      Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

    11. Return the ftont airbag sensor RH and LH to their original positions and connect the connectors.


    A

    USE SIMULATION METHOD TO CHECK Click here

    B

    REPLACE AIRBAG SENSOR ASSEMBLY Click here

    C

    REPLACE FRONT AIRBAG SENSOR RH Click here