AIRBAG CUT-OFF SWITCH INSPECTION

PROCEDURE


  1. INSPECT AIRBAG CUT OFF SWITCH CYLINDER SUB-ASSEMBLY


    1. Check the resistance.


      1. A001UTBC15
        *a

        Component without harness connected

        (Airbag Cut Off Switch Cylinder Sub-assembly)

        Measure the resistance according to the value(s) in the table below.

        Standard Resistance
        Tester Connection Condition Specified Condition
        2 (PMC+) - 1 (PMC-) Cut off switch in ON position 360 to 440 Ω
        2 (PMC+) - 1 (PMC-) Cut off switch in OFF position 90 to 110 Ω

        If the result is not as specified, replace the airbag cut off switch cylinder sub-assembly.