VANITY LIGHT SWITCH INSPECTION

PROCEDURE


  1. INSPECT VISOR ASSEMBLY LH


    1. A001U8BC15
      *a

      Component without harness connected

      (Visor Assembly LH)
      *b Visor up
      *c Visor down
      *d Mirror Cover

      Check the resistance.


      1. Measure the resistance according to the value(s) in the table below.

        Standard Resistance
        Tester Connection Condition Specified Condition
        1 - 2 Visor up 10 kΩ or higher
        1 - 2 Mirror cover fully closed with visor down 10 kΩ or higher
        1 - 2 Mirror cover fully open with visor down Below 1 Ω

        If the result is not as specified, replace the visor assembly LH.

  2. INSPECT VISOR ASSEMBLY RH


    1. A001TH1C15
      *a

      Component without harness connected

      (Visor Assembly RH)
      *b Visor up
      *c Visor down
      *d Mirror Cover

      Check the resistance.


      1. Measure the resistance according to the value(s) in the table below.

        Standard Resistance
        Tester Connection Condition Specified Condition
        1 - 2 Visor up 10 kΩ or higher
        1 - 2 Mirror cover fully closed with visor down 10 kΩ or higher
        1 - 2 Mirror cover fully open with visor down Below 1 Ω

        If the result is not as specified, replace the visor assembly RH.